Fixed Resistor

A fixed resistor is part of an electric circuit and is used to reduce the flow of electricity. Resistance is measured in Ohms and is typically shown as the number and then the units. For example, a 750 Ohm resistor would be written as 750-Ohm. The size of the resistor is based on the number of Ohms and can range from pin to book size.

Resistors come in two classes: fixed and variable. A fixed resistor is set at a specific value and cannot be changed. A variable resistor is able to manage flows at a specific level and below. This is an important distinction and determines when and where a resistor should be used.

When selecting a resistor, it is important to consider three things: the value of the resistor, tolerance, and power rating. The value of the resistor is measured in Ohms. The tolerance indicates the upper and lower bounds of actual performance. This is measured in plus and minus percentage. For example, a tolerance of 10 percent means that the resistor performs within a 10 percent range of the resistance value listed in the specifications.

Power rating shows the upper limit of power that can be managed by the fixed resistor. This is measured in watts. To calculate the power, multiply the resistance value of the resistor by the square root of the current. If the power rating is exceeded, the resistor will fail. A rule of thumb is to use a resistor with a power rating two times higher than the actual power needed.

There are two kinds of fixed resistors: carbon and metal film. Carbon film resistors are designed for general use and are fairly cheap to produce and purchase. These units have a tolerance of 5 percent, with power ratings of 1/8 Watts (W), 1/4W, and 1/2W. The primary issue with this type of resistor is the fact they generate electrical noise.

A metal film fixed resistor is best utilized when a higher tolerance is required. These units have a greater level of accuracy than carbon film resistors, due to the nature of the materials used. There is a corresponding increase in price, but it may be well worth the incremental cost to protect the other components of the circuitry.

When reviewing the different types of resistors, think about the intended use of the circuit. Select a manufacturer with a good reputation for quality and consistency. Take the time to test the resistor and the circuit before installation to ensure all the specifications are correct.

For more details : Fixed Resistor